1. The composition of the wireless remote control system of the concrete pump

The remote control system of the concrete pump  is composed of a transmitting system and a receiving system. The transmitting system is the remote control in the hands of the pumper. The control signal is sent out through an external transmitting antenna. The receiving system is generally installed in the cab and receives the transmitter’s Signals, and through modulation and demodulation, read the instructions issued by the transmitter, and control the work of each boom section by controlling the boom multi-way valve.

The wireless remote control distance of the pump truck is controlled within 200 meters. The remote control system can work normally within this range. If the distance exceeds this distance, the signal may be lost and the remote control will be lost.

Second, the correct use steps

1. When using the remote control of the pump truck for the first time, you need to put the special remote control battery into the charger for more than 14 hours to activate the battery.

2. Install the battery on the remote control, paying attention to the front and back of the battery when installing.

3. Check whether the external antenna on the remote control and the suction cup antenna on the receiver are installed in place.

4. When the receiver of the receiving system is powered on, the yellow and red indicator lights on it are always on, indicating that the receiving system is normally powered on.

5. After turning on the key switch of the launching system (and at the same time dialing the red emergency stop button on the launching system), the indicator light on the launching system will begin to flash quickly (the system is in frequency sweeping at this time), and after a few seconds, the indicator light will change to Flashing rhythmically. At this time, the indicator lights on the receiving system have changed from one yellow and one red to one yellow and one green. The remote control system is activated. When you press the electric whistle button on the transmitting system, you can hear the electric whistle on the car body, indicating that the receiving system is controlled.

6. Different toggle switches on the remote control can achieve different functions. The operator uses these switches to control the boom of the pump truck to achieve different actions.