Concrete mixers are necessary on construction sites because they can save a lot of manpower, thereby saving economic costs and improving work efficiency. But if you want the mixer to play its due role and efficiency, you need to store the sicoma mixer accessories and maintain the accessories
 

sicoma mixer accessories

 

1. When the mixer is working outdoors, it should be selected to work on a flat ground and covered with wooden boards to prevent the machine from affecting the use efficiency. Cover it with a hood at night or in rain and snow or move it to a dry room.

2. Before long-term storage, the machine must be maintained, repaired and damaged parts must be repaired and thoroughly cleaned to keep the technical condition in good condition.

3. The mixing work area should be selected in an open place, not affected by the entry and exit of other machinery.

4. The mechanical fuel control lever should be placed in the idle position, and each control lever should be placed in the neutral position.

5. Maintenance of mixer engine: ①Drain the cooling water in the engine ②Replace the engine oil. The new oil is usually neutral and will not corrode the metal parts of the engine. ③ Fill the fuel tank with diesel fuel to prevent the fuel tank from rusting. If conditions permit, preservatives should also be added. ④ During the shutdown period, the engine should be started once a month to make the machine travel a short distance, so that a new oil film is established at the lubrication point of each part to prevent rust. It should be noted that the cooling water should be filled before starting, and the cooling water should be discharged at the end.

6. Maintenance of the battery: ① The battery should be removed and placed in a dry and frost-proof place. To keep the surface clean and dry, it is strictly prohibited to place conductive objects on the battery. When disassembling the battery, first cut the negative wire, and then cut the positive wire; when installing, first connect the positive wire, and then connect the negative wire. Because the electrical system of construction machinery is grounded with negative pole, this is to prevent short circuit when disassembling the battery. ②Lead-acid batteries should be charged once a month.

7. The anti-rust treatment of construction machinery: ① Before storage, the size of the peeling area of the anti-rust paint on the outer surface should be determined to determine whether to use the method of paint repair or the method of repainting the whole machine; , Such as the screed of the paver, the bucket of the loader, the scraper of the grader, etc., the method of anti-rust on the exposed areas of the metal is to apply butter.